Gem cli is a tool used to make diagnostics on this king of storage.

You need to connect the ethernet ports on the LAN, use either DHCP, or fix IP

DHCP is enabled by default when your system meets the following requirements:

Notes:

• Do not connect the Ethernet port to the public network. It is recommended that all the ESM Ethernet ports are in the local area network.
• If the EC number on the label of ESM is 019609 or later, the firmware installed on the ESM has newer version and the static IP addresses on each Ethernet port are as follows:
  • ESM 0: 192.168.0.101
  • ESM 1: 192.168.0.102
• When the Storage D3284 is used as the expansion enclosure of Storage DS-series, the Ethernet connector on each ESM is disabled

GEM CLI can be accessed via Telnet by connecting to the Ethernet port of a controller and using the command

Telnet <ESM IP>

The default account and password are:

• User name: cliuser
• Password: L@12sT12 (case sensitive)

Note: After replacing the chassis, the password will be restored to the default value. Reset the password as needed.

Example of help command:

help [all] | [<cmd>]