This is an old revision of the document!
Storage D1212 install
GEM CLI
Gem cli is a tool used to make diagnostics on this king of storage.
You need to connect the ethernet ports on the LAN, use either DHCP, or fix IP
DHCP is enabled by default when your system meets the following requirements:
System | EC number on the label of ESM | Firmware version |
D1212/D1224 | N34768 | 5.0.0.15 |
D3284 | N34764 | 5.0.0.17 |
Notes:
Do not connect the Ethernet port to the public network. It is recommended that all the ESM Ethernet ports are in the local area network.
If the EC number on the label of ESM is 019609 or later, the firmware installed on the ESM has newer version and the static IP addresses on each Ethernet port are as follows:
ESM 0: 192.168.0.101
ESM 1: 192.168.0.102
When the Storage D3284 is used as the expansion enclosure of Storage DS-series, the Ethernet connector on each ESM is disabled