Differences

This shows you the differences between two versions of the page.

--- aix:power10_hmc [2024/02/09 21:55]
manu
+++ aix:power10_hmc [2024/02/09 22:13] (current)
manu
@@ Line 4: / Line 4: @@
 https://www.ibm.com/support/pages/ibm-power-systems-power10-servers
+https://www.ibm.com/support/pages/connecting-power-10-ebmc-system-hmc
 Before Power 10, only one IP address was requested on power servers ASMI to manage it.
@@ Line 9: / Line 11: @@
 FIXME Now you have first the eBMC, but before starting a power 10, also add a VMI IP address.
   default login/password for eBMC: admin / admin
+FIXME **There are no default IP addresses anymore**, to access ASM (eBMC) using a browser. You should use **panel function 30** to what the IP address may be set to. Panel is located in front of the server, you have buttons: up, down and select
 {{aix:p10_ebmc01.png?650|}}
@@ Line 17: / Line 22: @@
 Before power on the server choose **action**, and **VMI configuration** (IP address), if IP is static, then configure one, else change to DHCP.
+  Select the same eBMC network interface the HMC is cabled to.
+  Note that the adapters may list eth1 first, however eth0 is typically used for the first HMC. If 2 HMC are used, both have to be setup
+//Note// the eBMC port used on the Power 10 system (first (T0) HMC port = eth0, second (T1)HMC port = eth1)
 If this step is missed, when server is started, you 'll have a connection lost on the HMC !

wiki