aix:power10_hmc
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
aix:power10_hmc [2024/02/09 22:04] manu |
aix:power10_hmc [2024/02/09 22:13] (current) manu |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| FIXME Now you have first the eBMC, but before starting a power 10, also add a VMI IP address. | FIXME Now you have first the eBMC, but before starting a power 10, also add a VMI IP address. | ||
| default login/password for eBMC: admin / admin | default login/password for eBMC: admin / admin | ||
| + | |||
| + | FIXME **There are no default IP addresses anymore**, to access ASM (eBMC) using a browser. You should use **panel function 30** to what the IP address may be set to. Panel is located in front of the server, you have buttons: up, down and select | ||
| + | |||
| {{aix:p10_ebmc01.png?650|}} | {{aix:p10_ebmc01.png?650|}} | ||
| Line 21: | Line 24: | ||
| Select the same eBMC network interface the HMC is cabled to. | Select the same eBMC network interface the HMC is cabled to. | ||
| Note that the adapters may list eth1 first, however eth0 is typically used for the first HMC. If 2 HMC are used, both have to be setup | Note that the adapters may list eth1 first, however eth0 is typically used for the first HMC. If 2 HMC are used, both have to be setup | ||
| + | |||
| + | //Note// the eBMC port used on the Power 10 system (first (T0) HMC port = eth0, second (T1)HMC port = eth1) | ||
| If this step is missed, when server is started, you 'll have a connection lost on the HMC ! | If this step is missed, when server is started, you 'll have a connection lost on the HMC ! | ||
aix/power10_hmc.1707512697.txt.gz · Last modified: 2024/02/09 22:04 by manu
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
