storage:brocade_cmd
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
storage:brocade_cmd [2024/11/04 17:04] manu [Firmware Download] |
storage:brocade_cmd [2025/05/15 11:38] (current) manu [Virtual Fabric] |
||
|---|---|---|---|
| Line 245: | Line 245: | ||
| </cli> | </cli> | ||
| - | ==== Firmware Download ==== | + | ==== FPGA upgrade ==== |
| The firmware download does not automatically update the FPGA firmware into the FPGA flash memory of the system. If an updated FPGA version is included in a Fabric OS firmware update, after the firmware download is completed, you must enter the fpgaupgrade command to update the FPGA firmware | The firmware download does not automatically update the FPGA firmware into the FPGA flash memory of the system. If an updated FPGA version is included in a Fabric OS firmware update, after the firmware download is completed, you must enter the fpgaupgrade command to update the FPGA firmware | ||
| Line 1284: | Line 1284: | ||
| Assign a port to a virtual fabric (port will be disabled for this operation) | Assign a port to a virtual fabric (port will be disabled for this operation) | ||
| lscfg --config 99 -port 5 | lscfg --config 99 -port 5 | ||
| + | |||
| + | FIXME To use fosexec, you have to allow it into **configure** to authorize **Remote fosexec feature** | ||
| Start a command under a specific fabric ID (FID)FID can be all | Start a command under a specific fabric ID (FID)FID can be all | ||
storage/brocade_cmd.1730736249.txt.gz · Last modified: 2024/11/04 17:04 by manu
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
