storage:brocade_cmd
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
storage:brocade_cmd [2024/11/04 17:04] manu [Firmware Download] |
storage:brocade_cmd [2025/09/04 18:26] (current) manu [Virtual Fabric] |
||
|---|---|---|---|
| Line 1284: | Line 1284: | ||
| Assign a port to a virtual fabric (port will be disabled for this operation) | Assign a port to a virtual fabric (port will be disabled for this operation) | ||
| lscfg --config 99 -port 5 | lscfg --config 99 -port 5 | ||
| + | |||
| + | FIXME To use fosexec, you have to allow it into **configure** to authorize **Remote fosexec feature** | ||
| Start a command under a specific fabric ID (FID)FID can be all | Start a command under a specific fabric ID (FID)FID can be all | ||
| fosexec --fid FID -cmd "command" | fosexec --fid FID -cmd "command" | ||
| - | | + | |
| + | fosexec Command in FOS 9.2+ | ||
| + | The fosexec command still exists in FOS 9.2.x, but its access is restricted: | ||
| + | |||
| + | **Only users with admin or maintenance roles can execute fosexec starting FOS 9.2.0a.** | ||
| + | userconfig --create Myuser -r admin -l 1-128 -c operator | ||
| ==== Hard Zoning ==== | ==== Hard Zoning ==== | ||
storage/brocade_cmd.1730736278.txt.gz · Last modified: 2024/11/04 17:04 by manu
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
